代码之家 › 专栏 › 技术社区 › j2abro

从SD卡中闪烁Google Coral板失败,错误为:“source”命令的图像格式错误

google-coral sd-card

0

j2abro · 技术社区 · 3 年前

闪烁a coral dev board 根据 getting started guide Wrong image format for "source" command . 当SD卡插入主板并且主板通电时,串行控制台显示此错误-下面是完整输出。我没有找到这个问题的任何文件,所以我把它张贴在这里,以防其他人有这个问题。

U-Boot SPL 2019.04.1 (Apr 29 2020 - 18:40:05 +0000)
power_bd71837_init
Board id: 2
DDRINFO: start DRAM init
DDRINFO:ddrphy calibration done
DDRINFO: ddrmix config done
Normal Boot
Trying to boot from MMC2
hdr read sector 300, count=1


U-Boot 2019.04.1 (Apr 29 2020 - 18:40:05 +0000), Build: jenkins-enterprise.uboot-imx-1

CPU:   Freescale i.MX8MQ rev2.0 1500 MHz (running at 1000 MHz)
CPU:   Commercial temperature grade (0C to 95C) at 33C
Reset cause: POR
Model: Freescale i.MX8MQ Phanbell
DRAM:  1 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... *** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial

 BuildInfo:
  - ATF
  - U-Boot 2019.04.1

flash target is MMC:0
Net:
Error: ethernet@30be0000 address not set.

Error: ethernet@30be0000 address not set.
eth-1: ethernet@30be0000
Fastboot: Normal
Normal Boot
Hit any key to stop autoboot:  0
** No partition table - mmc 1 **
## Executing script at 40480000
Wrong image format for "source" command
## Starting auxiliary core at 0x00000000 ...
u-boot=>

1 回复 | 直到 3 年前

1

0

j2abro 3 年前

这个错误是由坏的SD卡引起的,或者可能是已经被用于其他用途(格式化)的SD卡。我能够绕过这个错误,并成功地安装了操作系统通过燃烧的形象,每 getting started guide 在 (我用的是三星128GB Pro耐久卡)。我曾经 balenaEtcher